Canon i-SENSYS LBP151dw User Manual page 104

5
Set the IP address.
Automatically assigning an IP address
1
In the [Select Protocol] list, select [DHCP], [BOOTP], or [RARP].
If you do not want to use DHCP/BOOTP/RARP to assign an IP address automatically
Select [Off]. If you select the [DHCP], [BOOTP], or [RARP] protocol when these services are unavailable,
the machine will waste time and communications resources searching the network for these services.
2
Check that [Auto IP] is set to [On].
● If [Off] is selected, change the setting to [On].
Even if Auto IP is enabled, IP addresses assigned via DHCP/BOOTP/RARP override an address obtained via
Auto IP.
Manually entering an IP address
1
Select [Off] for [Select Protocol] and [Auto IP].
2
Set the [IP Address], [Subnet Mask], and [Gateway Address] fields.
6
Click [OK].
Checking whether the settings are correct
Make sure that the Remote UI screen can be displayed with your computer.
If you change the IP address after installing the printer driver
If you are using an MFNP port, and the machine and the computer are in the same subnet, then the connection
will be maintained. You do not need to add a new port. If you are using a standard TCP/IP port, then you need
to add a new port. Configuring Printer Ports(P. 110)
Network
99
Starting the Remote UI(P. 175)