Configuring Module Interface Shared Resources
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 3-8
PortChannel
Members
Generation 3
interfaces
1. If resources are not available.
Use the show port-channel compatibility parameters command to obtain information about
PortChannel addition errors.
Configuring Module Interface Shared Resources
This section describes how to configure Generation 2 and Generation 3 module interface shared
resources and contains the following sections:
•
•
•
•
•
•
•
•
•
•
•
Displaying Interface Capabilities
Before configuring a Generation 2 or Generation 3 interface, you can use the show interface
capabilities command to display detailed information about the capabilities of the interface.
Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide
3-14
PortChannel Configuration and Addition Results (continued)
Configured Speed
PortChannel
Auto
Auto max 2000
Auto max 2000
Auto
Auto max 2000
Auto
Displaying Interface Capabilities, page 3-14
Configuration Guidelines for 48-Port, 24-Port, and 4/44-Port 8-Gbps Fibre Channel Switching
Modules, page 3-15
page 3-17
Releasing Shared Resources in a Port Group, page 3-34
New Member
New Member
Type
Auto
Generation 1
Auto
Generation 1
Auto
Generation 2
Auto max 2000 Generation 2
Auto
Generation 3
Auto max 2000 Generation 3
Chapter 3
Configuring Fibre Channel Interfaces
Addition Type
Normal or force
Normal or force
Normal
Force
Normal
Force
Normal
Force
Normal
Force
OL-19445-02, Cisco MDS NX-OS Release 4.2(x)
Result
Fail
Pass
Fail
Pass
Fail
Pass
Fail
Pass
Fail
Pass