Cisco MDS 9000 Series Configuration Manual page 46

Fibre Channel Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
fc9/10
fc9/11
-------------------------------------------------------------------------------
Interface
-------------------------------------------------------------------------------
port-channel 1
port-channel 2
The show interface transceiver command can only be issued on a switch in the Cisco MDS 9100 Series
Note
if the SFP is present (see
Example 2-10 Displays Transceiver Information
switch# show interface transceiver
fc1/1 SFP is present
name is CISCO-AGILENT
part number is QFBR-5796L
revision is
serial number is A00162193
fc-transmitter type is short wave laser
cisco extended id is unknown (0x0)
...
fc1/9 SFP is present
name is FINISAR CORP.
part number is FTRJ-1319-7D-CSC
revision is
serial number is H11A6ER
fc-transmitter type is long wave laser cost reduced
cisco extended id is unknown (0x0)
...
Example 2-11
interfaces have multiple entries in the configuration files to ensure that the interface configuration
commands execute in the correct order when the switch reloads.
Example 2-11 Displays the Running Configuration for All Interfaces
switch# show running-config
...
interface fc9/1
switchport speed 2000
...
interface fc9/1
switchport mode E
...
interface fc9/1
channel-group 11 force
no shutdown
Example 2-12
configuration commands are grouped together.
Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide
2-26
0 4186
0 4331
Input (rate is 5 min avg)
-----------------------------
Rate Total
Mbits/s Frames
0 0
0 3946
Example 2-10).
displays the entire running configuration with information for all interfaces. The
displays the running configuration information for a specified interface. The interface
Chapter 2
0 4182
0 4315
Output (rate is 5 min avg)
-----------------------------
Rate Total
Mbits/s Frames
0 0
0 3946
OL-19445-02, Cisco MDS NX-OS Release 4.2(x)
Configuring Interfaces