Displaying Vsan Interface Information; Default Settings - Cisco MDS 9000 Series Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Displaying VSAN Interface Information

To display VSAN interface information, use the show interface vsan command.
switch# show interface vsan 2
vsan2 is up, line protocol is up
Default Settings
Table 2-7
Table 2-7
Parameters
Interface mode
Interface speed
Administrative state
Trunk mode
Trunk-allowed VSANs or VF-IDs
Interface VSAN
Beacon mode
EISL encapsulation
Data field size
Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide
2-50
WWPN is 10:00:00:05:30:00:59:1f, FCID is 0xb90100
Internet address is 10.1.1.1/24
MTU 1500 bytes, BW 1000000 Kbit
0 packets input, 0 bytes, 0 errors, 0 multicast
0 packets output, 0 bytes, 0 errors, 0 dropped
lists the default settings for interface parameters.
Default Interface Parameters
Chapter 2
Default
Auto
Auto
Shutdown (unless changed during initial setup)
On (unless changed during initial setup) on
non-NPV and NPIV core switches. Off on NPV
switches.
1 to 4093
Default VSAN (1)
Off (disabled)
Disabled
2112 bytes
OL-19445-02, Cisco MDS NX-OS Release 4.2(x)
Configuring Interfaces