Cisco MDS 9000 Series Configuration Manual page 61

Chapter 2 Configuring Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 4
switch(config-port-group-monitor)# monitor
counter rx-performance
switch(config-port-group-monitor)# monitor
counter tx-performance
switch(config-port-group-monitor)# no
monitor counter tx-performance
1. See Reverting to the Default Policy for a Specific Counter, page
2. See Default Policy, page 2-41
3. See Turning Off the Monitoring of a Specific Counter, page
Default Policy
The default policy has the following threshold values:
Counter
RX Performance
TX Performance
Reverting to the Default Policy for a Specific Counter
When the no counter command is used in the config-port-group-monitor mode, the specified counter
polling values will revert to the default values as seen in the following example:
switch(config)# port-group-monitor name PGMON_policy
switch(config-port-group-monitor)# counter tx-performance poll-interval 100 delta
rising-threshold 65
switch(config)# show port-group-monitor PGMON_policy
Policy Name
Admin status : Not Active
Oper status
Port type
------------------------------------------------------------------------------------------
Counter
-------
RX Performance
TX Performance
switch(config)# port-group-monitor name PGMON_policy
switch(config-port-group-monitor)# no counter tx-performance
switch(config)# show port-group-monitor PGMON_policy
Policy Name
Admin status : Not Active
Oper status
Port type
------------------------------------------------------------------------------------------
Counter
-------
RX Performance
TX Performance
------------------------------------------------------------------------------------------
OL-19445-02, Cisco MDS NX-OS Release 4.2(x)
Threshold Type Interval (Seconds) % Rising Threshold
Delta 60
Delta 60
falling-threshold 25
: PGMON_policy
: Not Active
: All Port Groups
Threshold Interval %ge Rising Threshold %ge Falling Threshold
--------- -------- -------------------- ---------------------- ------
Delta 60
Delta 100
: PGMON_policy
: Not Active
: All Port Groups
Threshold Interval %ge Rising Threshold %ge Falling Threshold
--------- -------- -------------------- ---------------------- ------
Delta 60
Delta 60
Purpose
Turns on Rx performance monitoring.
Turns on Tx performance monitoring.
3
Turns off Tx performance monitoring.
2-41.
2-42.
80
80
80 10
65 25
80 10
80 10
Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide
Configuring Port Group Monitor
% Falling Threshold
20
20
In Use
Yes
Yes
In Use
Yes
Yes
2-41