Cisco ONS 15600 Series Reference Manual page 318

C.3 Node Default Settings
•
•
•
•
•
Any node level defaults changed using the Provisioning > Defaults tab, changes existing node level
Note
provisioning. Although this is service affecting, it depends on the type of defaults changed, for example,
general, and all timing and security attributes. The "Changing default values for some node level
attributes overrides the current provisioning." message is displayed. The Side Effects column of the
Defaults editor (right-click a column header and select Show Column > Side Effects) explains the effect
of changing the default values. However, when the card level defaults are changed using the
Provisioning > Defaults tab, existing card provisioning remains unaffected.
For more information about each individual node setting, refer to the "Change Node Settings" chapter
Note
of the Cisco ONS 15600 Procedure Guide.
Table C-4 Node Default Settings
Default Name
NODE.circuits.State
NODE.circuits.upsr.ReversionTime
NODE.circuits.upsr.Revertive
NODE.circuits.upsr.STS_SDBER
NODE.circuits.upsr.STS_SFBER
NODE.circuits.upsr.VT_SDBER
NODE.circuits.upsr.VT_SFBER
NODE.general.DefaultsDescription
Cisco ONS 15600 Reference Manual, R7.0
C-26
Security Access settings—Set default security settings for LAN access, shell access, serial craft
access, element management system (EMS) access (including Internet Inter-Object Request Broker
Protocol [IIOP] listener port number), TL1 access, and SNMP access.
Security RADIUS settings—Set default RADIUS server settings for accounting port number,
authentication port number, and whether to enable the node as a final authenticator.
Security Policy settings—Set the allowable failed logins before lockout, idle user timeout for each
user-level, optional lockout duration or manual unlock enabled, password reuse and change
frequency policies, number of characters difference between the old and new password, password
aging by security level, enforced single concurrent session per user, and option to disable inactive
user after a set inactivity period.
BITS Timing settings—Set the coding, framing, and state settings for building integrated timing
supply 1 (BITS-1) and BITS2 timing.
General Timing settings—Set the mode (External, Line, or Mixed), quality of reserved (RES) timing
(set the rule that defines the order of clock quality from lowest to highest), revertive, reversion time,
and SSM message set for node timing.
Appendix C Network Element Defaults
Default Value Default Domain
IS,AINS IS, OOS,DSBLD,
OOS,MT,
IS,AINS
5.0 (minutes) 0.5, 1.0, 1.5 ..
12.0
FALSE TRUE, FALSE
1.00E-06 1E-5, 1E-6, 1E-7,
1E-8, 1E-9
1.00E-04 1E-3, 1E-4, 1E-5
1.00E-06 1E-5, 1E-6, 1E-7,
1E-8, 1E-9
1.00E-04 1E-3, 1E-4, 1E-5
Factory Free form field
Defaults