Asap Card Pos Ports Utilization Window; Asap Card Pos Ports History Window - Cisco ONS 15600 Series Reference Manual

Multiservice switching platform (mssp)
Hide thumbs Also See for ONS 15600 Series:
Table of Contents

Advertisement

Chapter 12
Performance Monitoring
Table 12-9
Parameter
Tx Octets
Rx Shorts
Rx Runts
Rx Longs
Rx CRC Errors/HDLC Errors
Rx Single Bit Errors
Rx Multi Bit Errors
Rx Type Invalid
Rx Input Abort Packets
Rx Input Drop Packets

12.6.2.5 ASAP Card POS Ports Utilization Window

The POS Ports Utilization window shows the percentage of Tx and Rx line bandwidth used by the POS
ports during consecutive time segments. The Utilization window provides an Interval menu that enables
you to set time intervals of 1 minute, 15 minutes, 1 hour, and 1 day. Line utilization is calculated with
the following formulas:
Rx = (inOctets * 8) / interval * maxBaseRate
Tx = (outOctets * 8) / interval * maxBaseRate
The interval is defined in seconds. The maxBaseRate is defined by raw bits per second in one direction
for the Ethernet port (that is,1 Gbps). The maxBaseRate for ASAP cards is shown in
page
Line utilization numbers express the average of ingress and egress traffic as a percentage of capacity.
Note

12.6.2.6 ASAP Card POS Ports History Window

The Ethernet POS Ports History window lists past Ethernet POS Ports statistics for the previous time
intervals. The History window displays the statistics for each port for the number of previous time
intervals as shown in
ASAP Card POS Ports Parameters (continued)
12-16.
Table
12-8. The listed parameters are defined in
12.6.2 ASAP Card Ethernet Performance Monitoring Parameters
Meaning
Number of bytes transmitted (to the SONET/SDH path) after the
bytes undergoing HLDC encapsulation by the policy engine.
Number of packets below the minimum packet size received.
Total number of frames received that are less than 5 bytes.
Number of received frames that exceed the maximum transfer
unit (MTU).
HDLC errors received from SONET/SDH.
Number of received frames with single bit errors.
Number of received frames with multibit errors.
Number of received frames with invalid type.
Number of received packets aborted before input.
Number of received packets dropped before input.
Cisco ONS 15600 Reference Manual, R7.0
Table 12-7 on
Table 12-9 on page
12-16.
12-17

Advertisement

Table of Contents
loading

Table of Contents