4.8 Software Load Revert
The ONS 15600 does not allow you to restore a database from one node to another node. You can install
Note
a database from one node on another node by using the Configure Node option on the Maintenance >
Database tab.
4.8 Software Load Revert
Before you upgrade to Software Release 7.0, you must create a database backup. If you later need to
restore the original working software load from the protect software load, CTC displays a prompt
requesting the location of the backup. Any provisioning performed with Software R7.0 will be lost when
the Software R1.1.x backup is restored.
After a software load is activated (upgraded to a higher software release), any circuits created and
Note
provisioning performed will not reinstate if an older database is restored. The database configuration at
the time of activation is reinstated after a revert.
Cisco ONS 15600 Reference Manual, R7.0
4-16
Chapter 4
Cisco Transport Controller Operation