View Or Change Cellular Network Settings - NETGEAR Arlo Go User Manual

3. Select the Arlo Go camera that you want to update.
4. Tap or click Device Info > Firmware > Update.
WARNING: Do not disconnect your camera, open the battery door, or remove the
battery while the firmware update is in progress.
5. Wait for the firmware update to complete.
The camera's LED blinks amber and blue while the firmware is downloading and
installing. After the firmware is installed, the camera reboots and the LED is off.
When the LED lights again and the pattern stops changing, your camera is available
to stream.

View or Change Cellular Network Settings

¾ To view or change cellular network settings:
1. Tap the Arlo icon
You can also enter
The Devices page displays.
2. Tap or click Settings.
The Settings page displays.
3. Select the Arlo Go camera.
The My Devices page displays.
4. Scroll down to the NETWORK section.
This section displays technical information about the Arlo Go camera's cellular
network connection settings.
5. To view or change APN settings, tap or click APN Settings.
If the camera is offline, a QR code displays. Otherwise, the Edit APN page
displays.
Changing the APN might cause your camera to be unreachable to the network.
Do not change these settings unless instructed to do so by network support.
6. If a QR code displays, aim the camera at the QR code, and follow the onscreen
instructions.
7. To change the network mode from the Edit APN page, select Auto, LTE Only, or
HSPA/HSPA+ Only.
Settings
on your mobile device.
arlo.netgear.com in the address bar of a browser.
48