Honeywell GNS-XLS Operator's Manual page 245

4. Enter the departure time for which FDE prediction desired.
5. ENTER Key - DEPRESS.
6. Enter the desired route spacing in nautical miles. 60NM is nor-
mal.
7. ENTER Key - DEPRESS.
8. Enter the expected ground speed in knots. A value of 100 to 999
Kts may be entered.
9. ENTER Key - DEPRESS.
10. Enter the starting waypoint of the active flight plan leg for which
FDE prediction is being calculated. Pressing the BACK Key will
cycle through the waypoints on the active flight plan. Dashes are
displayed prior to the last waypoint on the flight plan. Pressing
ENTER while the dashes are displayed will clear the start and
end waypoints, resulting in an undefined Oceanic/Remote seg-
ment.
11. ENTER Key - DEPRESS.
12. Enter the ending waypoint of the active flight plan leg for which
FDE prediction is being calculated. The BACK and dashes oper-
ate the same here as in the previous step.
13. ENTER Key - DEPRESS.
14. If no satellites are to be excluded from the FDE prediction,
DEPRESS the lower right Line Select Key and proceed to Step
20. If specific satellites are to be excluded from the FDE predic-
tion, go to Step 15.
15. ENTER Key - DEPRESS
to display the FDE
EXCLUDE SATS 1/1
Page. See Figure 3-208
16. Line Select
DEPRESS to position
the cursor in the SAT #
field.
17. Enter the satellite num-
ber to be excluded.
Rev. 3
Sep/96
FDE EXCLUDE SATS 1/1
EXCLUDED SATS LIST
Key -
OK? ENTER
GNS-X Flight Management System
LS
System Operation
SAT #--
Figure 3-208
<
<
3-131