Maintenance; Replacing Carbon Brushes - Makita 8406c Instruction Manual

through the workpiece.
Always secure small workpieces in a vise or similar
•
hold-down device.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
1
007613
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
1. Limit mark
1
1. Screwdriver
2. Brush holder cap
2
or attachments
injury to
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Tungsten-carbide tipped hammer bit
•
Diamond core bit (Dry type)
•
Center bit
•
Center bit shank
•
Diamond core bit (wet type)
•
Guide ring
•
Sheet
•
Sponge
•
Water protection collar
•
Blow-out bulb
•
Safety goggles
•
Chuck key
•
Side grip
•
are
10
persons. Only use accessory or