Mounting Workpiece To Backing Block; Outboard Turning - Grizzly G0733 Owner's Manual

Figure 40.
NOTICE
Only use screws with non-tapered heads
(see Figure 41) to attach the faceplate to
the workpiece. Screws with tapered heads
can split the faceplate or snap off during
operation.
Figure 41.
3.
Faceplate Page 25
Mounting the Workpiece
to a Backing Block
Mounting Workpiece to Backing
Block
1.
2.
3.
4.
5.
Headstock
Note: The faces of the backing block must be
flat and parallel to each other, or the uneven
surfaces will cause the workpiece to spin
eccentricly, causing unnecessary vibration
and runout. It is best to mount the backing
block to the faceplate and turn the other sur-
face flat prior to mounting.
Note: Allow the glue to cure according to the
manufacturer's instructions.
Steps 1–3
Workpiece onto the Faceplate
33

Outboard Turning

Mounting the
Page