Grizzly G0733 Owner's Manual page 30

2.
3.
4.
5.
Figure 37.
6.
Figure 38
Figure 38.
Step 1
Figure 37
7.
Installing/Removing Headstock Center
Page 23
Note: Use the tool rest to support the opposite
end of the workpiece so that the workpiece
and spur center do not separate during
installation.
8.
9.
10.
Do not press the workpiece too firmly with
the tailstock or the bearings will bind and
overheat. Do not adjust the tailstock too
loosely or the workpiece will spin off the
lathe. Use good judgment and care, other-
wise, serious personal injury could result
from the workpiece being ejected at high
speeds.
11.
Adjusting Tool Rest
12.
Keep the lathe tool resting on the tool
rest the ENTIRE time that it is in contact
with workpiece or when preparing to make
contact between lathe tool and workpiece.
Otherwise, the spinning workpiece could
force the lathe tool out of your hands or
entangle your hands with the workpiece.
Failure to heed this warning could result in
serious personal injury.
Page 24
Page 23