GE H
DRAFT
EALTHCARE
D
5460683, R
IRECTION
EVISION
3-7-2-3
During a normal boot, you may observe
A.) Power is distributed to Peripherals, Operator Panel (control panel), Monitor, Front-End and
Back-End Processor.
B.) The Back-End Processor and rest of the scanner starts with the sequence listed in following steps:
1.) "Boot Screen" is displayed.
2.) Back-End Processor is turned ON and starts to load the software.
3.) The Start Screen (LOGIQ™) is displayed on the monitor.
4.) Start-up progress bars indicating software loading procedures, are displayed on the monitor,
3
DRAFT (J
as shown in
Figure
3-12. and
Figure 3-12 GE Healthcare wallpaper with progress bar (R1.x.x)
Chapter 3 - Setup Instructions
25, 2014)
UNE
Figure 3-12
below.
LOGIQ™ S7 E
/P
XPERT
RO
S
M
ERVICE
ANUAL
3-23