Advertisement
Available languages
Available languages
Troubleshooting
Will not work
• Switch not in the ON position
• Juice Press Arm not lowered
• Juicing Cone or Fruit Dome not assembled properly
• Filter not assembled properly
• Motor Overload Protection may have operated (see below)
Motor Overload
Protection
• The Citrus Press is equipped with with an internal overload protector to
prevent the motor from being damage under heavy or continuous loads.
If
the
motor suddenly stops working, turn OFF the ON/OFF button and unplug the
unit from the power outlet. Allow the unit to cool for up to 30 minutes before
operating again.
NOTE: The unit MUST be unplugged from the power outlet to properly cool.
• Despite this overload protector, we suggest juicing in smaller batches in order
to protect the Motor.
1:1
Care
&
Cleaning
• Always ensure that the citrus press is turned
OFF at the ON/OFF switch and the plug
is removed from the power outlet before
cleaning, disassembling, assembling and
storing the appliance.
• Follow these instructions to clean all surfaces
or parts that come into contact with food
during juicing.
• For easy cleaning immediately after each use
rinse removable parts under warm water to
remove wet pulp. Allow parts to air dry before
reassembling.
• For thorough cleaning after disassembling
the appliance, all removable parts should be
washed in hot soapy water or on the top shelf
of the dishwasher. The base and juice press
arrn should be wiped with a soft, damp cloth.
All parts should be dried thoroughly before
reassembling.
• Store the cleaned and reassembled citrus
press in an upright position in a cool, dry
place. Do not place any items on top of the
citrus press while stored.
8
1•0
NOTE
• If
the motor stalls or strains under load, do
not operate continuously for more than 10
seconds at a time.
• Rinse or wash all removable parts
immediately after use. Dried citrus pulp
is diff:tcult to remove and rnay stain.
If
any
staining does occur, wipe the discoloured
part(s) with undiluted dishwashing liquid,
rinse and dry thoroughly.
• Do not soak the f:tlter or other removable
parts in bleach. Never immerse the motor
base in water or any other liquid. Do not use
harsh abrasives.
Advertisement
