Troubleshooting - Breville AquaStation LWA200BSS Instruction Book

Troubleshooting

PROBLEM/Error Code
Displayed on Screen
Slow water flow rate
Small amounts of black
particles in water tank
START/STOP
Button does not respond
Leakage from water tank
Odd taste of the water
"FILTER RESET" flashing
on LCD screen.
LO
HI
E03
E04
If you cannot remedy problems by using the troubleshooting chart above,
contact Breville Customer Service.
POSSIBLE CAUSE
•
Aging of pump or inlet at the
base of the purifier is clogged
•
These are small pieces of
carbon from the filter. These
carbon particles are food grade
and are not harmful. They will
not impair the performance of
your filter or unit.
•
The unit is not connected to
the power
•
The water tank is filled beyond
the maximum water level
•
Tank is not firmly pushed into
position
•
The filtered water is not used for
a long time
•
The filter has reached end of life
•
Filter needs to be changed
or filter reset has not been
actioned
•
Water temperature in water
tank less than 5 °C
•
Water temperature in water
tank is higher than 40 °C
•
Heating element malfunction
•
Dry boil protection
WHAT TO DO
•
Contact Breville Customer Service
•
Flush your water purifier and water
filter cartridge. Refer to 'Flushing the
Breville AQUASTATION™' (page 12)
and 'Preparing the Activ360 Filter'
(page 12)
NOTE: Some carbon fibre residual
may still be present after flushing the
water purifier and filter.
•
Plug in to a usable power outlet and
turn power on
•
Ensure water is only up to the MAX
water level marking. If leakage
continues, please contact Breville
Customer Service
•
Replace the water tank back on the
machine, pressing down to ensure
that it is properly positioned and
attached to the machine.
•
Discard the remaining water in the
water tank and refill with fresh tap
water. Depending on the length of
time, the filter may require re-flushing
•
Replace with new filter
•
Change the filter if required, turn the
FUNCTION dial until the indicator
on the LCD screen reaches the
FILTER RESET function and press
ADJUST/SET button once to reset.
•
Fill water between 5 °C to 40 °C
•
Fill water between 5 °C to 40 °C
•
Contact Breville Customer Service
•
Turn the unit off at the power and
Contact Breville Customer Service
23