GE Reason RT430 Technical Manual page 77

The S section of the Web Interface, shown in
ETUP
configurations, changing key, and changing configuration username and password. Firmware and key
updates will be described in
Figure 44: Section to update firmware, manipulate configurations, change key and change configuration username
To change the unit key, access the Web Interface S
browser and follow the steps below:
1. Enter the new
2. Click <A
3. After clicking <A
password. Enter username and password and click <L
<C
ANCEL
4. During the transmission, the unit will momentarily go out of operation. A message
communicating the key change will show up on the screen
and password window and the message after the transmission.
RT430-TM-EN-5
Chapter 4.
and password.
(36 alphanumeric characters) in the K
KEY
> to send the new key to the unit.
PPLY
>, a new window will open requesting username and configuration
PPLY
>.
Figure 44 , allows updating the firmware, manipulating
section, typing the unit IP address in a default
ETUP
field.
EY
OGIN
RT430
>. To cancel the action, click
shows the username
Figure 45
77