Events Input - GE Reason RT430 Technical Manual

GPS Grandmaster Clock
The system information is presented as follows:

Firmware Version: presents the current firmware version of the unit.

Serial Number: presents the serial number of the unit.

MAC Address E

Key: presents the unit key according to the enabled features (NTP and/or PTP); besides the key, it is
shown the current features configuration of each E
5.2.3

Events input

The section E of the Web Interface, shown in
VENT
pulses from event input of RT430. The timestamp frequency that is registered in log files is according to the
pulse frequency received through the event input.
This input can be used to check the PTP signal quality when RT430 is used as slave, i.e., receiver of PTP
signal from external sources connected to the network. The electrical output of the source should be
configured to send pulses in time frequency and in each pulse received by the unit, an event will be
registered in a log file, containing the timestamp of the pulse. The accuracy of event input is in the magnitude
of ns.
72
Figure 40: Section to visualize general information of the system
1/4: presents the MAC address of each E
THERNET THERNE
port.
THERNET
Figure 41 , allows monitoring the timestamp of received
t port.
RT430-TM-EN-5