GE Reason RT430 Technical Manual page 47

For direct communication using the electrical E
cable between the computer and the unit, as shown in
following pinout:
1
2
3
4
5
6
7
8
Figure 24: Direct communication architecture using the Ethernet electrical port
In the direct communication with the unit, it is necessary both the computer and the unit connected on the
same local network. To do so, configure the computer network connection according to the unit IP address,
and network mask, as the following example.
RT430 IP address, broadcast and network mask configuration:
RT430-TM-EN-5
THERNET
TABLE 29: Cross-over network cable pinout.
568 A
Striped white/green
Green
Striped white/orange
Blue
Striped white/blue
Orange
Striped white/brown
Brown
TABLE 30: RT430 IP address, broadcast, and network mask.
port, connect a 10/100 BaseT cross-over network
Figure 24 . The network cable should have the
568 B
1 Striped white / orange
2 Orange
3 Striped white / green
4 Blue
5 Striped white/blue
6 Green
7 Striped white/brown
8 Brown
RT430
47