Communication; Factory Default Settings - GE Reason RT430 Technical Manual

3. COMMUNICATION

3.1 Communication
RT430 has 2 Ethernet 10/100BaseT communication interfaces with RJ45 connector E
E 2 enabling redundancy.
THERNET
Connect a CAT5 cable with a RJ45 connector in each port. The L
transmitting signal, and the A
Figure 23: Electrical communication interface via Ethernet network
The Ethernet 1 communication interface can also be enabled to send PTP synchronism messages,
according to the unit model as
3.2

Factory default settings

Factory defaults for Ethernet ports are listed below:
RT430-TM-EN-5
shows one of the electrical communication interfaces.
Figure 23
led blinks when there is data exchange.
CTIVITY
Chapter 1 presents. For PTP protocol configuration details, see
TABLE 25: Ethernet 1 port are listed below.
IP Address
Netmask
Broadcast
led indicates that the cable is
INK
192.168.0.199
255.255.255.0
192.168.0.255
RT430
1 and
THERNET
Chapter 4.
45