Table of Contents
Advertisement
After connecting the unit to a network, see
To check if the unit is accessible, it is possible connect a cross-over network cable to the computer from a
terminal using command line, and run a ping command to the IP address of the unit.
3.6
Equipment access
A Web Interface allows configuring and monitoring the unit through a web browser, as the unit it is connected
to a local network.
To use all RT430 features through the Web Interface, make sure one of the web browsers below
(downloadable from the internet) are installed:
Internet Explorer versão 7 or superior.
Mozilla Firefox versão 3.0 or superior.
Connect to the Web Interface by entering the unit IP address into the address field of your web browser.
After the page is loaded, the unit Web Interface will open, and it is going to be possible to operate, monitor,
and configure it. See
Chapter 4
RT430-TM-EN-5
Section 3.6
for details on accessing the unit.
and
Chapter 5
for details on using the Web Interface.
RT430
49
Hide quick links:
Advertisement
Table of Contents
