Communication Via Ethernet Network - GE Reason RT430 Technical Manual

GPS Grandmaster Clock
Configure manually the computer local network connection to:
If the unit is not using factory default settings, see
address via local interface.
After connecting the unit to the computer, see
To check if the unit is accessible, it is possible connect a cross-over network cable to the computer from a
terminal using command line, and run a ping command to the IP address of the unit.
3.5

Communication via Ethernet network

For communication via E
connected, using a pin-to-pin cable, as shown in
In communication via network, it is necessary the unit and the computer to be in the same local subnet. It is
recommended the E
THERNET
i.e, the IP address, network mask, gateway, DNS and broadcast should be compatible with the network the
computer is connected to.
48
IP Address
Network mask
TABLE 31: Computer IP address, broadcast, and network mask.
IP Address
Network mask
section 3.6
port, connect one of the ports to the same network the computer is
THERNET
Figure 25: Architecture of communication via Ethernet port
port of the unit to be configured by a user to be compatible with a local network,
192.168.0.199
255.255.255.0
192.168.0.190
255.255.255.0
Chapter 5 for instructions to visualize the current IP
for details about accessing the unit.
.
Figure 25
RT430-TM-EN-5