Show Controllers Ethernet-Controller - Cisco ME 3800X Command Reference Manual

show controllers ethernet-controller

show controllers ethernet-controller
To display per-interface send and receive statistics read from the hardware, use the show controllers
ethernet-controller command in privileged EXEC mode without keywords. To display the interface
internal registers, use with the phy keyword or use the port-asic keyword to display information about
the port ASIC.
Syntax Description
interface-id
down-when-looped
phy
detail
| begin
| exclude
| include
expression
Command Modes Privileged EXEC (only supported with the interface-id keywords in user EXEC mode)
Command History Release
12.2(52)EY
Usage Guidelines
This display without keywords provides traffic statistics, basically the RMON statistics for all interfaces
or for the specified interface.
When you enter the phy keywords, the displayed information is useful primarily for Cisco technical
support representatives troubleshooting the switch.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Cisco ME 3800X and ME 3600X Switch Command Reference
-38
show controllers ethernet-controller [interface-id] [down-when-looped] [phy [detail]] [ | {begin
| exclude | include} expression]
The physical interface (including type, module, and port number).
Display the state related to the down-when-looped detection.
(Optional) Displays the status of the internal registers on the switch physical
layer device (PHY) for the device or the interface. This display includes the
operational state of the automatic medium-dependent interface crossover
(Auto-MDIX) feature on an interface.
(Optional) Displays details about the PHY internal registers.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Chapter
OL-28238-01