Mac Access-List Extended - Cisco ME 3800X Command Reference Manual

Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands

mac access-list extended

To create an access list based on MAC addresses for non-IP traffic, use the mac access-list extended
command in global configuration mode. Using this command puts you in the extended MAC access-list
configuration mode. To return to the default setting, use the no form of this command.
You cannot apply named MAC extended ACLs to Layer 3 interfaces or to Layer 2 interfaces with service
Note
instances configured.
name
Syntax Description
Defaults By default, there are no MAC access lists created.
Command Modes
Global configuration
Command History Release
12.2(52)EY
Usage Guidelines
MAC named extended lists are used with VLAN maps and class maps.
You can apply named MAC extended ACLs to VLAN maps or to Layer 2 interfaces, except Layer 2
interfaces that have service instances configured on them.
You cannot apply named MAC extended ACLs to Layer 3 interfaces.
Entering the mac access-list extended command enables the MAC access-list configuration mode.
These configuration commands are available:
•
•
•
•
•
You can verify MAC ACL configuration by entering the show access-lists privileged EXEC command.
OL-28238-01
mac access-list extended name
no mac access-list extended name
Assigns a name to the MAC extended access list.
Modification
This command was introduced.
default: sets a command to its default.
deny: specifies packets to reject. For more information, see the
configuration) MAC access-list configuration command.
exit: exits from MAC access-list configuration mode.
no: negates a command or sets its defaults.
permit: specifies packets to forward. For more information, see the
configuration) command.
deny (MAC access-list
Cisco ME 3800X and ME 3600X Switch Command Reference
mac access-list extended
permit (MAC access-list
2-147