NOTE:
Dust pack is a throw-away type.
•
When the sponge filter is clogged with dust, remove it
from the cleaner and then wipe it off or wash in water.
Removing and installing the sponge filter
1
008907
To remove the sponge filter, remove the dust bag or dust
pack and then pinch and take it out.
008902
1
008906
Press in the whole edge of the sponge filter against the
recessed wall inside the dust bag/dust pack mounting
area.
CAUTION:
After cleaning sponge filter, be sure to install it on
•
the cleaner. If washed in water, dry it up before
installing. An insufficiently dried sponge filter may
shorten the service life of the motor.
Disposing cleaner
A Ni-Cd battery is built into this cleaner. Always remove
it before disposing of the cleaner.
1. Sponge filter
1. Wall
9
Removing built-in battery
CAUTION:
Never remove the built-in battery from the cleaner
•
except when disposing of the cleaner. The battery
will be damaged or a battery short-circuit could
result.
Do not touch the terminals with any conductive
•
material.
Avoid storing battery unit in a container with other
•
metal objects such as nails, coins, etc.
Do not expose battery unit to water or rain.
•
Do not disassemble or alter battery unit.
•
1
008905
1.
To remove the rear cover, push it in the direction
of the arrow.
008904
2.
Withdraw the built-in battery halfway.
1
008903
3.
Disconnect the three lead wires from the battery
by pressing the connector on the part 1 in the
direction of arrow shown in the figure and pulling
them. Then withdraw the battery unit completely.
4.
Put the removed battery unit in a plastic bag so
that it is not circuit-shorted.
1. Rear cover
1. Battery unit
1
1. Connector