Functional Description - Makita 4076D Instruction Manual

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off before
•
adjusting or checking function on the tool.
Charging the built-in battery
1
008909
008910
Use only the Makita charger DC7021 to charge this
cleaner. Use of other type chargers may cause the
battery to burst, resulting in personal injury and damage.
Charge the cleaner when it is to be used for the first time
or it has been left uncharged for a long time. Connect
the charging plug to the charging connector, then plug in
the charger to the power receptacle. The light in front of
the cleaner switch will come on and charging will begin.
Charging takes approximately 3 - 5 hours. The light goes
out after the charging is complete. Refer to the
instruction manual for the charger for more details.
CAUTION:
Do not operate the cleaner during charging. It may
•
be damaged.
Always disconnect the charging plug from the
•
cleaner after charging.
When you charge a new cleaner or a cleaner
•
which has been left uncharged for a long time, it
may not accept a full charge. This is a normal
condition and does not indicate a problem. You can
recharge the cleaner fully after discharging it
completely a couple of times.
Maximum charging
•
depending on room temperature.
1. Charging
connector
2. Charging plug
2
1. Lamp
1
time may be
Switch action
008911
CAUTION:
Always be sure that the dust bag or paper pack is
•
installed properly in the cleaner before use.
Improper installation may allow dust to enter the
motor, resulting in malfunction of the cleaner.
Always switch off the cleaner after each use to
•
prevent damage to the cleaner and to lengthen the
service life of the batteries.
This cleaner can be operated in "standard" and "strong"
suction. For standard suction, slide the switch forward to
the LOW position. For strong suction, slide the switch
further to the HIGH position.
To stop the cleaner, slide the switch back to the OFF
position.
ASSEMBLY
Dust disposal
CAUTION:
Empty the cleaner before it becomes too full, or the
•
suction force weakens.
Be sure to empty out the dust inside the cleaner
•
itself. Failure to do so may cause the sponge filter
to be clogged or the motor to be damaged.
Never throw away the dust stopper because it
•
should be used whenever either the dust bag or
the dust pack is used.
1
008917
9 hours
4
1. Switch
1
1. Lever
A