Makita VC3211M Technical Manual page 17

W
iring diagram
2. Wiring in Separator complete
Fig. D-08
Put the following Lead wires between these ribs:
• Power supply cord's lead wire connected to Controller
• Controller's lead wires connected to DC motor
• Buzzer circuit's lead wires
• Vinyl tube to Pressure sensor
Cord guard
Cord guard
Do not place the slack
of Lead wires on
Cord guard.
If Line filter is used, wind Power supply
cord's lead wires one turn around Line
filter as shown below, then put Line filter
in this place.
Line filter
rib
Controller
Fix Buzzer circuit's lead wires
in this lead wire holder, then fix
Vinyl tube over them.
Vinyl tube
Buzzer circuit
Controller
If Line filter is used, wind AC motor's
lead wires one turn around Line filter
as shown below, then put Line filter in
this place.
Do not drop nor press
Buzzer circuit,
nor pull its lead wires
too strong.
Line filter
P 17/18
Fix Controller's lead wires
connected to DC motor
in this lead wire holder
so that they are tight
between DC motor and
this lead wire holder.
Connect Flag terminals
to DC motor so that
Lead wires run as shown
in the figure.
DC motor
red marking
Push Vinyl tube over
this boss firmly until
it stops.
Fix AC motor's lead
wires in these lead wire
holders.
Place the slack of
AC motor's lead wires
in this space.
Separator complete
Route AC motor's
lead wires through this
opening of Separator
complete; make sure
that they are tight inside
Separator complete.