Wiring Diagram - Makita VC3211M Technical Manual

W
iring diagram
1. AC motor unit
Fig. D-03
Fix two Field lead wires
to each Brush holder
in these lead wire holders.
Fig. D-04
Bind two Field lead wires
with at the exit
Band (cable tie)
of the shorter Field lead wire.
Field lead wire to Controller,
the shorter one
Field lead wire to Controller,
the longer one
Fig. D-05
Install Carbon brush as shown below:
1 Place the slack of the pig tail wire of Carbon brush
between the dotted line and the brush holding frame
of Carbon brush.
2 Connect the flag terminal on the pig tail wire to
Brush holder so that the pig tail wire runs as shown
in the dotted circle.
CORRECT
brush holding frame
AC motor unit,
viewed from top
Brush holder
pig tail wire of
Carbon brush
flag terminal
on pig tail wire
Field lead wire
to Controller
Brush holder
Field lead wire
to Controller
Make sure that the longer
Field lead wire is tight
between
Band (cable tie)
and the exit of the wire.
WRONG
The slack of
the pig tail wire
is out of place.
The pig tail wire is
not running right
due to wrong
connection of the
flag terminal to
Brush holder.
P 15/18