Page 1
INSTRUCTION MANUAL Rotary Hammer HR2800 HR2810 HR2810T HR2811F HR2811FT 008203 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING Read all safety warnings and all recycling facility. instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. For Model HR2800 ENE042-1 Save all warnings and Intended use instructions for future reference.
Page 3
Do not operate power tools in explosive 13. Remove any adjusting key or wrench before atmospheres, such as in the presence of turning the power tool on. A wrench or a key left flammable liquids, gases or dust. Power tools attached to a rotating part of the power tool may create sparks which may ignite the dust or fumes.
Service 12. Do not point the tool at any one in the area 24. Have your power tool serviced by a qualified when operating. The bit could fly out and repair person using only identical replacement injure someone seriously. parts. This will ensure that the safety of the power 13.
Page 5
B side for click can clearly be heard. counterclockwise rotation. Selecting the action mode CAUTION: For Model HR2800 Always check the direction of rotation before • 1. Action mode operation. changing knob Use the reversing switch only after the tool comes •...
For rotation only, turn the knob so that the arrow on the For chipping, scaling or demolition operations, rotate the knob points toward the symbol on the tool body. action mode changing knob to the symbol. Use a For rotation with hammering, turn the knob so that the bull point, cold chisel, scaling chisel, etc.
Page 7
Bit grease Bit angle (when chipping, scaling or demolishing) Coat the bit shank head beforehand with a small amount of bit grease (about 0.5 - 1 g). For models HR2810, HR2810T, HR2811F, HR2811FT This chuck lubrication assures smooth action and longer 1.
Dust cup CAUTION: There is a tremendous and sudden twisting force 1. Dust cup • exerted on the tool/bit at the time of hole break-through, when the hole becomes clogged with chips and particles, or when striking reinforcing rods embedded in the concrete. Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations.
Set the action mode changing knob so that the pointer maintenance or adjustment should be performed by points to the symbol. Makita Authorized Service Centers, always using Makita For model HR2810T, HR2811FT replacement parts. Use the quick change drill chuck as standard equipment.
Page 10
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. SDS-Plus Carbide-tipped bits • Bull point • Core bit •...