Printed Wiring Board - Makita BFL301F Technical Information

W
iring diagram
[2] Wiring Around Stator
Fig. D-3
Place Connectors and the slack
of lead wires in the space
between rib (E) and the inside
wall of Housing.
inside wall of Housing
Route the following lead wires from Controller
between rib (E) and the inside wall of Housing;
*wires to LED circuit
*wires to switch unit (for Clutch)
At this time, place the lead wires so that the tape
is positioned beside Printed wiring board.
Route the three lead wires
(orange, white, blue) from
Controller to Stator between
the pin and Stator.
First, put the following lead wires from Controller
in place;
*wires to LED circuit
*wires to switch unit (for Clutch)
Then, fix the lead wires (orange, white, blue)
from Controller in the lead wire holder,
Connector (to LED circuit)
tape
lead wire holder
Switch unit (for Clutch)
Connector
rib (E)

Printed wiring board

pin
Stator
rib (F) rib (G)
Route the six lead wires (orange, black, white,
yellow, blue, red) from Controller to Stator
between rib (F) and rib (G).
P 13/ 14