Makita BFL301F Technical Information page 12

W
iring diagram
[1] Wiring Around Controller
Fig. D-2
Route the lead wires from
Switch unit (for rotation
reverse) between rib (A)
and rib (B).
Route the lead wires from
Switch unit (for Trigger)
between rib (B) and rib (C).
Put the lead wires from
Controller to Buzzer on
the groove in Controller.
Install Connector
here.
Install Receptacles
on Terminal as
Lead wire (black)
drawn right.
Lead wire (red)
rib (A)
Switch
rib (B)
rib (C)
groove
Terminal
Motor control unit
Power supply
circuit
Sponge
Receptacles
P 12/ 14
Route the lead wires (orange,
white, blue) from Controller
to Stator between the two pins.
pin
rib (D)
Connector
Place Connectors and lead
wire slacks in the space
between ribs (A)- (B)- (C)
and pins- rib (D)- boss.
boss
Put Connector and the lead
wires from Controller to
Buzzer between the ribs
on Controller.
Connector
rib
Pin
Pass Lead wires from
Power supply circuit
between pins.