Wiring Diagram - Makita Makstar BFT121F Technical Information

W
iring diagram
BFT121F, 12V (with LED job light)
Put the slack lead wires and the following
connectors in this space.
* Connector of LED circuit
* Connector of switch unit
* 2 connectors of controller (also in case of mod. BFT120)
Be careful, not to pinch
the lead wires between
switch and housing, when
assembling.
Pass the following lead wires
between rib A and the wall of
housing.
* Controller's lead wires
(black and red) to be
connected to terminal
* Controller's lead wires
(white and red) to be
connected to buzzer circuit
Buzzer circuit has to be so mounted,
that the sponge side is faced to the
housing L side.
Endbell's
lead wire
(red)
Connectors
Rib A
Pass the endbell's lead wires (black and
red) both sides of LED cover portion
of controller.
Buzzer
circuit
Terminal
Put the connectors of controller and buzzer circuit
between the line and terminal as illustrated above.
Endbell's
lead wire
(black)
LED cover portion
Connectors
Pass the following lead wires
between the ribs of switch.
* Controller's lead wires (white
and orange) to be connected
to micro switch.
* Controller's lead wires (blue,
purple and white) to be
connected to reverse switch.
* Controller's lead wires (red
and white) to be connected
to buzzer circuit.
P 12 / 12
Rib