Maintenance - Makita 4101RH Instruction Manual

MAINTENANCE
CAUTION:
Always be sure that the
tool
is switched off and unplugged before attempting to perform
inspection or maintenance
After use
Blow away dust from the inside of the tool by running the tool at an idle for a while.
Brush off accumulation of dust on the base.
Accumulation of dust in the motor or on the base may cause a malfunction of the tool.
Cleaning covers
When accumulation of dust on the cover
"A" looks excessive, loosen the clamp and
remove the cover "A". Wash off accumula-
tion of dust inside the cover "A" and wipe
it. Then install the cover "A" on the tool so
that its side with "Upside
tf
"
mark faces
upward. Push the cover "A" toward the
motor as far as it will go and secure it by
tightening the clamp.
When changing the wheel, clean the cover
"B" at the same time. Loosen the screw
securing the cover "B" and remove the
cover "B". Wash off accumulation of dust
inside the cover "B" and wipe it. Then
attach the cover
"B"
to the tool by tighten-
ing the screw. Accumulation of dust inside
the covers may cause a malfunction of the
tool.
-
Cover
"A"
I
Screw
CAUTl
ON
:
When using the tool, be sure to attach the covers "A" and "B"
15