Makita 4101RH Instruction Manual page 13

Operation
Adjust the amount
of
water flow. Hold the
tool firmly. Set the base plate on the work-
piece to be cut without the wheel making
any contact. Then turn the tool on and wait
until the wheel attains full speed. Now
simply move the tool forward over the
workpiece surface, keeping it flat and ad-
vancing smoothly until the cutting is com-
pleted. Keep your cutting line straight and
your speed of advance uniform.
Sighting
For straight cuts, align the left edge of the
base with your cutting line on the work-
CAUTION :
.THIS TOOL SHOULD ONLY BE USED ON HORIZONTAL SURFACES.
*Be sure to move the tool forward in a straight line and gently. Forcing and exerting exces-
sive pressure or allowing the wheel to bend, pinch or twist in the cut can cause overheat-
ing of the motor and dangerous kickback of the tool.
*Since excessive cutting may cause overload of the motor, the depth of cut should not be
more than 20 mm (13/16") at a pass. When you wish to cut more than 20 mm (13/16")
deep, make a couple of passes with progressively deeper settings.
I
piece.
For
45"
bevel cuts, align the left edge of the
top guide with it.
Base
&
13