Makita 4101RH Instruction Manual page 12

Removing or installing diamond wheel
CAUTIO N
:
Always be sure that the tool is switched off and unplugged before installing or removing
the wheel.
Hold the outer flange with the wrench and
loosen the hex socket head bolt clockwise
direction with the hex wrench. Then
remove the hex socket head bolt, and outer
flange.
/ Loosen
\
Install the diamond wheel, outer flange
and hex socket head bolt onto the spindle.
Hold the outer flange with the wrench and
tighten the hex bolt in counterclockwise
direction with the hex wrench. BE SURE
TO TIGHTEN THE HEX SOCKET HEAD
BOLT SECURELY.
CAUTION:
Use only the Makita wrench and hex wrench to install or remove the wheel.
Installing cover "A"
Install the cover "A" on the tool so that its
side with "Upside
U"
mark faces upward.
12