Adjusting The Fastening Torque - Makita DF010D Instruction Manual

Adjusting the fastening torque

1
.
008713
The fastening torque can be adjusted in 21 steps by
turning the adjusting ring so that its graduations are
aligned with the pointer on the tool body. The fastening
torque is minimum when the number 1 is aligned with
the pointer, and maximum when the
aligned with the pointer.
The clutch will slip at various torque levels when set at
the number 1 to 21. The clutch is designed not to slip at
the marking.
Before actual operation, drive a trial screw into your
material or a piece of duplicate material to determine
which torque level is required for a particular application.
NOTE:
See the following chart for the relation between the
•
number of torque setting and fastening torque rate.
The fastening torque rate will be different depends
on materials. Make a test fastening to get the
desired torque before operation.
1. Graduation
2
2. Adjusting ring
3. Pointer
3
marking is
6