Using A Wps Button To Add A Wps Client - NETGEAR MBR624GU User Manual

3G Broadband Wireless Router MBR624GU User Manual

Using a WPS Button to Add a WPS Client

Any wireless computer or wireless adapter that will connect to the router wirelessly is a client. The
client must support a WPS button, and must have a WPS configuration utility, such as the
NETGEAR Smart Wizard or Atheros Jumpstart.
To use the router WPS button to add a WPS client:
1. Log in to the router at its default LAN address of http://192.168.0.1 with its default user name
of admin and default password of password, or using whatever LAN address and password
you have set up.
2. On the router main menu, select Add a WPS Client, and then click Next. The following screen
displays:
Figure 2-7
By default, the Push Button (recommended) radio button is selected.
3. Either press the WPS button on the side of the router, or click the onscreen button.
The router tries to communicate with the client for 2 minutes.
4. Go to the client wireless computer, and run a WPS configuration utility. Follow the utility's
instructions to click a WPS button.
5. Go back to the router screen to check for a message.
2-14
WPS button
v1.0, January 2009
Wireless Network Configuration