NETGEAR DGN2000 Reference Manual page 47

To connect a combination of non-WPS enabled and WPS-Enabled clients to the modem router:
1. Restore the modem router to its factory default settings (press both the Wireless and WPS
buttons on the side of the modem router for 5 seconds).
When the factory settings are restored, all existing wireless clients are disassociated and
disconnected from the modem router.
2. Configure the network names (SSIDs), select the WPA/PSK + WPA2/PSK radio button on the
Wireless Settings screen (see
and click Apply. On the WPA/PSK + WPA2/PSK screen, select a passphrase and click Apply.
Record this information to add additional clients.
3. For the non-WPS devices that you want to connect, open the networking utility and follow the
utility's instructions to enter the security settings that you selected in
PSK + WPA2/PSK security method, and passphrase).
4. For the WPS devices that you want to connect, follow the procedures in
Connect (WPS) to Configure Your Wireless Network and Security" on page
The settings that you configured in Step 2 are broadcast to the WPS devices so that they can
connect to the modem router.
Note: To make sure that your new wireless settings remain in effect, verify that the
Keep Existing Wireless Settings checkbox is selected in the Advanced WPS
Settings screen.
To view a list of all devices connected to your modem router (including wireless- and Ethernet-
connected), see "Viewing Attached Devices" in Chapter
Configuring Your Wireless Network and Security Settings
Wireless-N ADSL2+ Modem Router DGN2000 Reference Manual
"Manually Configuring Your Wireless Security" on page
v1.0, July 2008
step 2
"Using Push 'N'
4.
2-10)
(the SSID, WPA/
2-17.
2-21