Makita BFR540 Technical Information page 4

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Casing Assembly and Feeder Box Assembly
DISASSEMBLING
Disassemble by taking the steps described in Fig. 2 to Fig 17.
Fig. 2
1) Loosen Thumb screw M4x28
by turning counterclockwise.
Casing assembly
2) Then pull off Casing
assembly from Housing.
Fig. 4
4) Clamper and Compression spring 23 can now be
removed from Casing complete.
Casing complete
Fig. 5
5) Stopper on either side of Casing complete can be
removed by sliding it in the direction of the gray
arrow while lifting up its rear end with a slotted
screwdriver.
rear end of Stopper
rear end
of Stopper
Fig. 3
3) While pressing Clamper, remove three M4x12 Countersunk
Clamper
Compression spring 23
Clamper
head screws from Casing complete.
Countersunk head screw M4x12:
one on Thumb screw M4x28 side, two on the opposite side
Casing complete
Removing Insulation sleeve from Clamper
While pressing two of the three locking tabs of Insulation
sleeve inward using 1R291, push it off from Clamper.
Clamper
Insulation sleeve
1R291
Fig. 6
6) Remove (+) Shoulder flat head screw M3x5
together with Sleeve 4 using No.1 Phillips screwdriver.
Sleeve 4
(+) Shoulder flat head screw M3x5
P 4/16
Clamper
No.1 Phillips
screwdriver