Samsung iDCS 500 Programming Manual page 213

iDCS 500
TECHNICAL MANUAL
MMC: 601
DESCRIPTION:
This MMC is used to build all station groups. There are 30 programmable groups
available in a iDCS 500-M system and 50 for a iDCS 500-L system.
The options for setting up these groups are as follows: A through F.
A. TYPE: This is the type of group you are creating and can be one of the
following:
1. NORMAL: Used to assign stations in a ring group. The members can be
stations, common bell contacts or Ring over Page relays.
2. VMAA: Used to group a number of voice mail port extensions. These must
have been defined in MMC 207 as VMAA ports or they cannot be entered
here. Check all programming in MMC 726 to ensure that the In band DTMF
codes are properly set.
3. AA: This is used to group a number of AA ports. An Auto Attendant (AA) card
must be installed in the system to do this.
4. BI-VMS: This is the voice mail group for the built in Samsung Voice Mail
Card. When a Voice Mail Card is installed, group 529 must be programmed
as a BI-VMS group on a iDCS 500-M system and group 549 must be used for
a iDCS 500-L system. Group 529 and 549 are fixed for the voice mail card
use. If the voice mail card is not installed in the system, group 529 or 549
can be used as any other group can be used.
5. MESSAGE: Used to group a number of extensions to serve as a message
desk or message group. When one of the stations in this type of group
leaves a message to another station the messaged station will return the
message to the message group so any member can answer the call. If a
station is a member of more than one message group, then any message
indications made by that station would be for the first numerical message
group they are a member of. It is not recommended to program stations in to
multiple station groups. NOTE: Message group only in L version software.
6. UCD: Used to build a UCD group. The iDCS 500 will support two methods of
UCD:
ASSIGN STATION GROUP
PROGRAMMING
PART 2 JULY 2003
Table of
Contents
HOME
PAGE
HELP