Priority Commands (Layer 3 And 4); Map Ip Dscp (Global Configuration); Map Ip Dscp (Interface Configuration); Table 4-83 Priority Commands (Layer 3 And 4) - Samsung iES4028F Management Manual

Priority Commands (Layer 3 and 4)

This section describes commands used to configure Layer 3 and Layer 4 traffic
priority on the switch.
Command
map ip dscp
map ip dscp
show map ip dscp

map ip dscp (Global Configuration)

This command enables IP DSCP mapping (i.e., Differentiated Services Code Point
mapping). Use the no form to disable IP DSCP mapping.
Syntax
[no] map ip dscp
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The precedence for priority mapping is IP DSCP and default switchport
priority.
Example
The following example shows how to enable IP DSCP mapping globally:
Console(config)#map ip dscp
Console(config)#

map ip dscp (Interface Configuration)

This command sets IP DSCP priority (i.e., Differentiated Services Code Point
priority). Use the no form to restore the default table.
Syntax
map ip dscp dscp-value cos cos-value
no map ip dscp
• dscp-value - 8-bit DSCP value. (Range: 0-63)
• cos-value - Class-of-Service value (Range: 0-7)
Table 4-83 Priority Commands (Layer 3 and 4)
Function
Enables IP DSCP class of service mapping
Maps IP DSCP value to a class of service
Shows the IP DSCP map
Class of Service Commands
Mode
GC
IC
PE
4
Page
4-313
4-313
4-315
4-313