Replacing The Default Secure-Site Certificate; Figure 3-46 Https Settings - Samsung iES4028F Management Manual

3
Configuring the Switch
Web – Click Security, HTTPS Settings. Enable HTTPS and specify the port number,
then click Apply.
CLI – This example enables the HTTP secure server and modifies the port number.
Console(config)#ip http secure-server
Console(config)#ip http secure-port 443
Console(config)#

Replacing the Default Secure-site Certificate

When you log onto the web interface using HTTPS (for secure access), a Secure
Sockets Layer (SSL) certificate appears for the switch. By default, the certificate that
Netscape and Internet Explorer display will be associated with a warning that the
site is not recognized as a secure site. This is because the certificate has not been
signed by an approved certification authority. If you want this warning to be replaced
by a message confirming that the connection to the switch is secure, you must
obtain a unique certificate and a private key and password from a recognized
certification authority.
Caution:
For maximum security, we recommend you obtain a unique Secure Sockets
Layer certificate at the earliest opportunity. This is because the default
certificate for the switch is not unique to the hardware you have purchased.
When you have obtained these, place them on your TFTP server and transfer them
to the switch to replace the default (unrecognized) certificate with an authorized one.
Command Attributes
• TFTP Server IP Address – IP address of TFTP server which contains the
certificate file.
• Source Certificate File Name – Name of certificate file stored on the TFTP server.
• Source Private File Name – Name of private key file stored on the TFTP server.
3-78

Figure 3-46 HTTPS Settings

4-124
4-125