Honda 08E61-S84-100 Installation Instructions Manual page 3

4. Remove the switch trim (two clips and two
retaining tabs), then unplug the interior light
harness connector from the switch.
CLIPS (2)
5. Remove the fuel lid opener knob, then remove the
left front trim (three clips and two retaining tabs).
FUEL LID
OPENER
KNOB
CLIPS (2)
© 2002 American Honda Motor Co., Inc - All Rights Reserved.
INTERIOR
LIGHT
HARNESS
CONNECTOR
RETAINING
TAB
SWITCH
TRIM
INTERIOR
LIGHT
SWITCH
RETAINING
TABS (2)
LEFT
FRONT
TRIM
CLIP
6. Remove the weatherstrip from the left kick panel.
WEATHERSTRIP
LEFT KICK PANEL
7. Remove the upper clip from the left kick panel,
then pull the left kick panel out toward you to
release the remaining clip.
8. Position the unit bracket on the control unit, and
install the two 4 x 30 mm washer-screws and two
flange nuts.
FLANGE NUT
CONTROL
UNIT
4 x 30 mm WASHER-SCREW
AII 23619 (0205)
CLIP
CLIP
UNIT
BRACKET
3 of 7