Contents Introduction ...3 Precautions ...4 Remote Control Transmitter Controls and Functions ...6 Battery Replacement ...8 Remote Control Code Programming How to Program Remote Control Transmitters ... 9 Please write the serial number of the remote control below. Keep this booklet as a record of your purchase.
Congratulations on your purchase of this Honda Keyless Entry System. Your Honda Keyless Entry System is the product of years of research and development. It will give you many years of reliable performance, protection, and convenience. The system consists of a remote control transmitter. The remote control allows you to operate from outside the vehicle while simultaneously locking and unlocking the doors.
Precautions Remote Control Range Several factors affect and reduce remote control range. Among these are: 1. Proximity to buildings and automobiles. 2. Proximity to high power transmitters (television, radio, cellular, HAM radio, etc.). 3. When the battery becomes weak, the remote control range becomes short.
Page 5
Battery Power In Case of Loss Use the remote control transmitter If one of your remote control transmitters is ever lost, contact your only when necessary. local Honda dealer for a replacement. Your system will be Every time a button is pressed, reprogrammed to prevent the lost remote control transmitter from the remote control is consuming operating your system.
Remote Control Transmitter • The doors cannot be locked or unlocked with the remote control transmitter when the key Controls and Functions is in the ignition switch. • The doors cannot be locked if any one of the doors is open. •...
Page 7
Remote Control Transmitter PANIC Button When this button is pressed and held for more than 1 second, the keyless entry system is set to the panic mode. The horn will sound for 30 seconds and the parking light and headlights will flash. To deactivate the panic mode, press the "LOCK", "UNLOCK"...
Remote Control Transmitter Battery Replacement The remote control transmitter requires one lithium battery (#CR2025). Using a coin (Quarter) turn the battery cover counterclockwise and remove the cover from the back of the remote control. Remove the used battery. Make sure you install the new battery with the proper polarity. Note: If the Lithium battery is incorrectly placed (+ and –...
Remote Control Code Programming • For steps 2 through 12, each step must be completed within 5 seconds. For step 13, How to Program Remote within 10 seconds for each remote. • Up to 3 remotes can be stored in memory. Control Transmitters •...
Page 10
Remote Control Code Programming Press the "LOCK" or "UNLOCK" button on the remote control transmitter. Turn the ignition to the "OFF" (0, ) position. Turn the ignition to the "ON" ( ) position. Press the "LOCK" or "UNLOCK" button on the remote control transmitter.
Page 11
Remote Control Code Programming Press the "LOCK" or "UNLOCK" button on the remote control transmitter. • The power door locks cycle to indicate programming mode. • To terminate the programming mode at this point, either turn the ignition key to the "OFF"...
Dimensions ... 30.7 mm × 65 mm × 11.5 mm(1-3/16" × 2-9/16" × 15/32") Net Weight ... 21 g (0.7 oz) NOTE: Due to continuous product improvement, specifications and design are subject to change without notice. 08E65-S5D-1000-81 American Honda Motor Co., Inc. 2000 All Rights Reserved.