Casio FX-730P Owner's Manual page 88

78
CHAPTER 4 Programming with BASIC Language
"LOAD
#"
is used to load data in the DAT A BANK from a tape to the com-
puter.
The previous data are erased when new data are loaded .
However, if ", M" is specified at the end of the LOAD
#
command, the data
from the tape are loaded following the previously stored data left intact.
LOAD# "File name"
Up to 8 characters.
Example:
LOAD# ''MEMO''
~
When data in the DATA BANK are being loaded, a display depending on the
storing format appears.
Storing format Display
SAVE# MF:
SAVE# "file name"
MF: file name
• Data Storing and Loading
A program always has data; it is troublesome to enter these data from the key-
board each time.
Try a method by which data in the computer are stored on tape and loaded
again .
To store data on a tape, "PUT" is used.
Variables are specified in a PUT command. A file name can also be specified.
PUT "File name"
Up to 8 characters.
Variable 1, Variable 2
For a file name, up to 8 characters can be placed inside " " as for program
storing.
If the exclusive character variable ($) is used, specify it first. Then next two
variable names are specified to determine the beginning and end of the variables
to be stored.