Pass - Casio FX-730P Owner's Manual

PASS
Function:
"Password"
Character string
Specifies or cancels a password.
Parameter:
Password :
1
~character string~
8.
Explanation:
6-1 Manual Commands
1) If this command
is executed when a password is not specified, a password is
specified for all program areas
(PO~
P9).
2) If this command is executed while a password is specified, this password is
canceled only when entering the corresponding password. When passwords do
not correspond, a protect error (Error 8) occurs.
3) A password consists of a 1
~
8 character string in which spaces, alphabetical
characters, numerals, special symbols, etc . can be used. However,(") cannot
be used.
4) While a password is specified, commands such as LIST, LIST ALL, LIST #,
LIST V, NEW, NEW ALL, and NEW# cannot be used. Also no writing (WRT
mode) can be made; it is attempted, an error (Error 8) occurs.
5) Can.not be used in a program.
6) A password can be maintained while the power switch is off.
7) If a program is stored on a cassette tape by a SA VE or SA VE ALL command
while a password is specified, this password is also stored. When a program
with a password attached is loaded from a cassette tape by a LOAD or LOAD
ALL command, the password is also loaded . Also, when a currently specified
password in the mainframe and the password of a program loaded from a
cassette tape are different, the program cannot be loaded from a cassette tape
(Error 8).
103