Casio FX-730P Owner's Manual page 63

;
...
:
:
4-1 Writing Programs
f .-, . ,
• !..f !..f
The number at the upper right part of the display indicates the remaining capac-
ity (number of bytes) of the area in which programs or data can be written (free
area). The free area will be 7520 bytes when nothing is written and these numbers
will decrease each time a program or data is written.
This operation erases the programs in all program areas and variable contents,
and prepares program area PO.
Let us now write the previously mentioned program.
ITJ[@§§J~ §§le:, 0000EI §§le:, GJOO§l
~[@rnEl~OOOO§§Jci~ffi~ITJOOOOffiITJ~§§l
~[@~~§§Je:,0rn0E1§§Je:,§§!6rn §l
~[@§§)~ITJ[@§J
§[@W@CID§J
The program will be stored with the above key operation. Do not forget to press
the
§I
key at the end of each line since the line will be stored only by pressing
§I .
Since one-key input is also possible for frequently used commands such as
INPUT and PRINT, speedy inputs will be possible. (For example, the five
characters "INPUT" can be input by
pressing~
IX] .
CIJ(N)~(IDITJ
can also be
applied.)
• Method of Correcting Program Errors
I) When an error is found during input before
0
is pressed:
Move the cursor to the error position by a cursor movement key (
El
or
El )
and correct the error. (Same as in Chapter 2)
2) When an error is found after storing the line by pressing
0:
Enter LIST line No .
§I
in the WRT mode to display the contents of the line
and correct as in I) above.
53