Time Programs Menu - Honeywell SDC Operating Instructions Manual

SDC / DHC 43

4.2.2 Time programs Menu

IMPORTANT!
EN2H-0220 GE51 R1005
rices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - info@mytu
In this menu, the time programs can be set individually
for the heating and DHW modes. The P1 standard
program set at the factory (also P2 and P3, if enabled)
for each heating or DHW circuit can be overwritten with
individual switching times and temperature values. This
is particularly useful if specific personalized heating
programs are to be created in case of periodically
recurring events with varying times (e.g. work shifts,
etc.).
For the programming of the switching times a maximum
of 3 heating cycles with their own switch-on and switch-
off times are available for each weekday. Each heating
cycle can be combined also with a freely selectable
temperature setpoint.
The standard programs are not lost if they are
overwritten with personalized programs. Personalized
programs will be deleted if the standard program is
reloaded and hence need to be created again. For this
reason the personalized switch-on and switch-off times
as well as the temperature values should be entered in
the tables envisaged for this purpose.
Entry See Menu Selection.
Termination In order to terminate and return to the basic display,
press "operating mode" key ¢ or wait the INFO-TIME
set for automatic termination.
26
Operation