Table of Contents
Advertisement
Chapter 3 Appendix
(2)
Error reporting via beep
Even if an error is detected by POST, the error message may be unable to be displayed in the display. In this
case, the server beeps to report that an error has occurred.
For example, the beep code 1-3-3-1 indicates 1 beep, a pause, 3 beeps, a pause, 3 beeps, a pause, and 1 beep,
which means that an error occurred while checking the memory capacity.
The table below shows the beep code, description, and solution.
Beep Code
1-3-3-1
1-5-2-1
1
2
3
4
5
7
8
140
Description
No memory module is not installed.
Or, no memory is detected.
The processor is not installed.
Or, no processor is detected.
POST detected an error.
Updated BIOS data was detected.
Failed to read BIOS data.
Or, failed to execute BIOS.
Failed to initialize the BIOS executable
module.
No graphics controller could be detected.
Failed to reset the system.
An error was detected when allocating the
PCI resources.
Express5800/R120d-1E, R120d-2E Maintenance Guide
Solution
Make sure that the DIMMs are correctly
inserted.
If this does not resolve the problem, contact
your sales representative.
Make sure that the processor is correctly
mounted. If this does not resolve the problem,
contact your sales representative.
Contact your sales representative.
This is not an error.
Wait until BIOS update completes.
Contact your sales representative.
Remove all the installed PCI boards to PCI
slots, and then reboot the server.
If the same error is detected repeatedly,
contact your sales representative.
1. Error Message
Advertisement
Table of Contents
