Activating Transformation Machine Data Via Parts Program/Softkey; Functionality - Siemens SINUMERIK 840D sl Function Manual

7.8

Activating transformation machine data via parts program/softkey

7.8
7.8.1

Functionality

Transformation MD can now be activated by means of a program command softkey, i.e.
these can, for example, be written from the parts program, thus altering the transformation
configuration completely.
Up to ten different transformations can be set in the control system. The transformation type
is set in the following machine data:
MD24100 $MC_TRAFO_TYPE_1
up to
MD24460 $MC_TRAFO_TYPE_10.
Characteristics
Transformation machine data are NEWCONFIG effective.
The protection level is now 7/7 (KEYSWITCH_0), which means that data can be modified
from the NC program without any particular authorization.
Provided that no transformation is selected (activated) when a NEWCONF command is issued
(regardless whether via the NEWCONF NC program command, the HMI or implicitly
following Reset or end of program), the machine data listed above can be altered without
restriction and then activated.
Of particular relevance is that new transformations can be configured or existing
transformations replaced by one of a different type or deleted, since the modification options
are not restricted to re-parameterization of existing transformations.
Extended Functions
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
7.8 Activating transformation machine data via parts program/softkey
M1: Kinematic transformation
577